MIB Viewer

PKTC-EN-SIG-MIB

40 objects
This MIB module enhances the basic management objects defined for PacketCable Signaling protocols by the MIB group pktcSigMib. Acknowledgements: Rodney Osborne - Arris Interactive Eugene Nechamkin - Broadcom Corporation Satish Kumar - Texas Instruments Jean-Francois Mule - CableLabs Copyright 1999-2004 Cable Television Laboratories, Inc. All rights reserved.
OIDNameAccessStatusDescription
1.3.6.1.4.1.4491.2.2.6.2IdentitypktcEnSigMibThis MIB module enhances the basic management objects defined for PacketCable Signaling protocols by the MIB group pktcSigMib. Acknowledgements: Rodney Osborne…
1.3.6.1.4.1.4491.2.2.6.2.1NodepktcEnSigMibObjects
1.3.6.1.4.1.4491.2.2.6.2.1.1NodepktcEnSigDevConfigObjects
1.3.6.1.4.1.4491.2.2.6.2.1.1.1ScalarpktcEnNcsMinimumDtmfPlayoutread-writecurrentThis object defines the minimum playout time for the DTMF digit when IETF RFC 2833 DTMF Relay is used for the egress gateway. If the value set via this pktcEnN…
1.3.6.1.4.1.4491.2.2.6.2.1.2NodepktcEnNcsEndPntConfigObjects
1.3.6.1.4.1.4491.2.2.6.2.1.2.1TablepktcEnNcsEndPntConfigTablenot-accessiblecurrentThis table augments pktcNcsEndPntConfigTable.
1.3.6.1.4.1.4491.2.2.6.2.1.2.1.1RowpktcEnNcsEndPntConfigEntrynot-accessiblecurrentAn enhancement to pktcNcEndPntConfigTable - where each entry describes endpoint characteristics.
1.3.6.1.4.1.4491.2.2.6.2.1.2.1.1.1ColumnpktcEnNcsEndPntQuarantineStateread-onlycurrentThis object reflects the state of the Endpoint. When the endpoint is in notification, lockstep or values 'extended lockstep' states, the E-MTA MUST report the …
1.3.6.1.4.1.4491.2.2.6.2.1.2.1.1.2ColumnpktcEnNcsEndPntHookStateread-onlycurrentThis object reflects the 'hook state' and 'NCS Activity' of an endpoint. 'NCS Activity', by definition includes: an active timeout signal, active brief signal …
1.3.6.1.4.1.4491.2.2.6.2.1.2.1.1.3ColumnpktcEnNcsEndPntFaxDetectionread-writecurrentThis MIB object is used to configure the distinctive fax calling tone (CNG) detection feature on an MTA endpoint with reference to the analog interface[po1]. W…
1.3.6.1.4.1.4491.2.2.6.2.1.2.1.1.4ColumnpktcEnNcsEndPntStatusReportCtrlread-writedeprecatedThis MIB object is be used to control the Endpoint Status Reporting, if the feature is supported by the MTA and is configurable. The term 'Endpoint Status Repo…
1.3.6.1.4.1.4491.2.2.6.2.1.2.2TablepktcEnEndPntInfoTablenot-accessiblecurrentThis table includes any additional information associated with PacketCable EndPoints. The number of entries in this table represents the number of available Pa…
1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1RowpktcEnEndPntInfoTableEntrynot-accessiblecurrentAn entry in this table MUST be created for each PacketCable EndPoint. The index needs to be the corresponding index in the ifTable for the associated PacketCab…
1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1.1ColumnpktcEnEndPntFgnPotSupportread-onlycurrentThis MIB object indicates the capabilities of the MTA to detect various conditions related to the presence of foreign potential on an endpoint. The MTA MUST se…
1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1.2ColumnpktcEnEndPntFgnPotDescrread-onlycurrentThis MIB object provides information related to the various tests for each detection mechanism supported by the MTA. While the actual contents are vendor-speci…
1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1.3ColumnpktcEnEndPntClrFgnPotTstsread-writecurrentThis MIB object is used to clear the current test results of supported conditions indicated by 'pktcEnEndPntFgnPotSupport'. Setting a bit to a value of '1' cle…
1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1.4ColumnpktcEnEndPntRunFgnPotTstsread-writecurrentThis MIB object is used to initiate one or more test cases associated with a supported foreign potential detection. Thus, whenever one or more BITS correspondi…
1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1.5ColumnpktcEnEndPntFgnTestValidityread-onlycurrentThis MIB object is used to indicate the validity of the corresponding test cases that were initiated using the MIB Object 'pktcEnEndPntRunFgnPotTests'. An MTA …
1.3.6.1.4.1.4491.2.2.6.2.1.2.2.1.6ColumnpktcEnEndPntFgnTestResultsread-onlycurrentThis MIB object is used to indicate the results of the corresponding test cases that were initiated using the MIB Object 'pktcEnEndPntRunFgnPotTests'. An MTA M…
1.3.6.1.4.1.4491.2.2.6.2.1.2.3TablepktcEnNcsEndPntLVMgmtTablenot-accessiblecurrentThis MIB table contains the MIB Objects used for managing loop voltage on an MTA. An MTA MUST implement the defined MIB Objects and the associated functionalit…
1.3.6.1.4.1.4491.2.2.6.2.1.2.3.1RowpktcEnNcsEndPntLVMgmtTableEntrynot-accessiblecurrentEach entry in this MIB table consists of the loop voltage management policy for the specified index. The MTA MUST use the ifIndex with a value of '1' to repres…
1.3.6.1.4.1.4491.2.2.6.2.1.2.3.1.1ColumnpktcEnNcsEndPntLVMgmtPolicyread-writecurrentThis MIB Object allows the Service Provider to choose a suitable policy for Loop Voltage behavior on MTAs. Unless overridden by the operator, the MTA MUST use …
1.3.6.1.4.1.4491.2.2.6.2.1.2.3.1.2ColumnpktcEnNcsEndPntLVMgmtResetTimerread-writecurrentThis MIB Object specifies the time duration allowed for an MTA to successfully provision and is only applicable when the MIB Object pktcEnNcsEndPntLVMgmtPolicy…
1.3.6.1.4.1.4491.2.2.6.2.1.2.3.1.3ColumnpktcEnNcsEndPntLVMgmtMaintTimerread-writecurrentThis MIB Object allows the operator to specify the time that loop voltage condition will be maintained, irrespective of the changes to the MTA. It is only appl…
1.3.6.1.4.1.4491.2.2.6.2.1.2.4TablepktcEnNcsEndPntLossTablenot-accessiblecurrentThe E-MTA supports two provisioned loss parameters, one for the D/A direction (towards the subscriber) and one for A/D direction (from the subscriber) directio…
1.3.6.1.4.1.4491.2.2.6.2.1.2.4.1RowpktcEnNcsEndPntLossEntrynot-accessiblecurrentThe E-MTA supports two provisioned loss parameters, one for the D/A direction (towards the subscriber) and one for A/D direction (from the subscriber) directio…
1.3.6.1.4.1.4491.2.2.6.2.1.2.4.1.1ColumnpktcEnNcsEndPntLossDAread-writecurrentThis object specifies the provisioned loss parameter for the D/A direction (towards the subscriber) in dB. The E-MTA MUST implement this element per the Packet…
1.3.6.1.4.1.4491.2.2.6.2.1.2.4.1.2ColumnpktcEnNcsEndPntLossADread-writecurrentThis object specifies the provisioned loss parameter for the A/D direction (from the subscriber)in dB. The E-fMTA MUST implement this element per the PacketCab…
1.3.6.1.4.1.4491.2.2.6.2.1.3NodepktcEnSigEndPntConfigObjects
1.3.6.1.4.1.4491.2.2.6.2.1.4NodepktcEnDcsEndPntConfigObjects
1.3.6.1.4.1.4491.2.2.6.2.2NodepktcEnSigNotificationPrefix
1.3.6.1.4.1.4491.2.2.6.2.2.0NodepktcEnSigNotification
1.3.6.1.4.1.4491.2.2.6.2.3NodepktcEnSigConformance
1.3.6.1.4.1.4491.2.2.6.2.3.1NodepktcEnSigCompliances
1.3.6.1.4.1.4491.2.2.6.2.3.1.1CompliancepktcEnSigBasicCompliancecurrentThe compliance statement for devices that implement PacketCable defined Signaling on an MTA.
1.3.6.1.4.1.4491.2.2.6.2.3.2NodepktcEnSigGroups
1.3.6.1.4.1.4491.2.2.6.2.3.2.1GrouppktcEnSigGroupcurrentEnhanced group of objects for the common portion of the PacketCable Signaling MIB.
1.3.6.1.4.1.4491.2.2.6.2.3.2.2GrouppktcEnNcsGroupcurrentEnhanced group of objects for the NCS portion of the PacketCable Signaling MIB. This is mandatory for NCS signaling support.
1.3.6.1.4.1.4491.2.2.6.2.3.2.3GrouppktcEnNcsLVMgmtGroupcurrentEnhanced group of objects for the loop voltage Management of PacketCable MTAs based on Signaling and configured policies.
1.3.6.1.4.1.4491.2.2.6.2.3.2.4GrouppktcEnNcsDeprecatedGroupdeprecatedThis contains a list of deprecated Extension Signaling MIB Objects.