TIARA-HSSI-MIB
27 objects
MIB definitions for Tiara HSSI modules.
Imported Objects
| RFC-1215 | TRAP-TYPE |
| SNMPv2-SMI | Counter32 Integer32 MODULE-IDENTITY OBJECT-TYPE |
| SNMPv2-TC | TruthValue |
| TIARA-NETWORKS-SMI | tiaraInterfaces |
| OID | Name | Access | Status | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.3174.2.7.2 | IdentitytiaraHssiMib | MIB definitions for Tiara HSSI modules. | ||
| 1.3.6.1.4.1.3174.2.7.2.1 | TablehssiConfigTable | not-accessible | current | The HSSI interface configurable parameters are listed in this table. |
| 1.3.6.1.4.1.3174.2.7.2.1.1 | RowhssiConfigTableEntry | not-accessible | current | HSSI table entry. |
| 1.3.6.1.4.1.3174.2.7.2.1.1.1 | ColumnhssiIfIndex | not-accessible | current | An integer value that is an index in the entries of the ifTable (MIB-II) with a HSSI interface type. |
| 1.3.6.1.4.1.3174.2.7.2.1.1.2 | ColumnhssiConfigClockRate | read-write | current | Configures the clock rate (in Hertz) for the HSSI interface. |
| 1.3.6.1.4.1.3174.2.7.2.1.1.3 | ColumnhssiConfigClockSource | read-write | current | Configures the clock source for the HSSI interface to either internal or line. |
| 1.3.6.1.4.1.3174.2.7.2.1.1.4 | ColumnhssiConfigTxClockSource | read-write | current | Configures the transmit clock source for the HSSI interface to either internal or terminal. This variable is valid only for the HSSI interface on the USSI card. |
| 1.3.6.1.4.1.3174.2.7.2.1.1.5 | ColumnhssiConfigRxClockSource | read-write | current | Configures the receive clock source for the HSSI interface to either internal or terminal. This variable is valid only for the HSSI interface on the USSI card |
| 1.3.6.1.4.1.3174.2.7.2.1.1.6 | ColumnhssiConfigMode | read-write | current | Configures the mode for the HSSI to either DCE or DTE. |
| 1.3.6.1.4.1.3174.2.7.2.1.1.7 | ColumnhssiConfigDataMode | read-write | current | Configures the data mode for the HSSI interface. This variable is valid only for the HSSI interface on the USSI card. |
| 1.3.6.1.4.1.3174.2.7.2.1.1.8 | ColumnhssiConfigCRC | read-write | current | Configures the cyclic redundancy check for the HSSI interface to either 16 or 32 bits. |
| 1.3.6.1.4.1.3174.2.7.2.1.1.9 | ColumnhssiConfigProcessCtrlSignal | read-write | current | Configures the processing of control signals (CA/TA) for the HSSI interface. This variable is valid only for the HSSI interface on the USSI card. |
| 1.3.6.1.4.1.3174.2.7.2.1.1.10 | ColumnhssiDteLoopback | read-write | current | Configures the local DTE for loopback operation: TRUE : request local DTE to go into line loopback FALSE : request local DTE to abandon line loopback These com… |
| 1.3.6.1.4.1.3174.2.7.2.1.1.11 | ColumnhssiDceLoopbackTest | read-write | current | Configures the local/remote DCE for loopback operation. Three DCE loopback modes are available: line, cable, and remote. Use noTest to abandon any of the DCE l… |
| 1.3.6.1.4.1.3174.2.7.2.2 | NodehssiTraps | |||
| 1.3.6.1.4.1.3174.2.7.2.2.1 | NodehssiAlarmOnTrap | HSSI alarm traps for the Alarm-On state. | ||
| 1.3.6.1.4.1.3174.2.7.2.2.1 | NodehssiTrapVariables | |||
| 1.3.6.1.4.1.3174.2.7.2.2.1.1 | ScalarhssiAlarmType | not-accessible | current | Specifies the type of alarm generated by the agent for the HSSI interface. Alarms are mode dependent; they are interpreted as follows: hssi-alarms-CA - CA not … |
| 1.3.6.1.4.1.3174.2.7.2.2.2 | NodehssiAlarmOffTrap | HSSI alarm traps for the Alarm-Off state. | ||
| 1.3.6.1.4.1.3174.2.7.2.3 | TablehssiStatsTable | not-accessible | current | The HSSI interface status parameters are listed in this table. |
| 1.3.6.1.4.1.3174.2.7.2.3.1 | RowhssiStatsTableEntry | not-accessible | current | HSSI Statistics table entry. |
| 1.3.6.1.4.1.3174.2.7.2.3.1.1 | ColumnhssiStatsAlarmStatus | read-only | current | Specifies the status of the HSSI alarm. If the particular bit is set, then it indicates that the alarm is in ON state. Alarm bits are mode dependent; they are … |
| 1.3.6.1.4.1.3174.2.7.2.3.1.2 | ColumnhssiStatsFramesIn | read-only | current | Specifies the number of incoming frames. |
| 1.3.6.1.4.1.3174.2.7.2.3.1.3 | ColumnhssiStatsFramesOut | read-only | current | Specifies the number of outgoing frames. |
| 1.3.6.1.4.1.3174.2.7.2.3.1.4 | ColumnhssiStatsOctetsIn | read-only | current | Specifies the number of incoming octets. |
| 1.3.6.1.4.1.3174.2.7.2.3.1.5 | ColumnhssiStatsOctetsOut | read-only | current | Specifies the number of outgoing octets. |
| 1.3.6.1.4.1.3174.2.7.2.3.1.6 | ColumnhssiStatsCRCErrors | read-only | current | Specifies the number of CRC errors that have been identified. |