Unisphere-Data-ETHERNET-MIB
47 objects
The Ethernet MIB for the Unisphere Networks enterprise.
Imported Objects
| IF-MIB | InterfaceIndex InterfaceIndexOrZero |
| SNMPv2-CONF | MODULE-COMPLIANCE OBJECT-GROUP |
| SNMPv2-SMI | Integer32 MODULE-IDENTITY OBJECT-TYPE |
| SNMPv2-TC | RowStatus TruthValue |
| Unisphere-Data-MIBs | usDataMibs |
| Unisphere-Data-TC | UsdNextIfIndex |
| OID | Name | Access | Status | Description |
|---|---|---|---|---|
| 1.3.6.1.4.1.4874.2.2.34 | IdentityusdEthernetMIB | The Ethernet MIB for the Unisphere Networks enterprise. | ||
| 1.3.6.1.4.1.4874.2.2.34.1 | NodeusdEthernetObjects | |||
| 1.3.6.1.4.1.4874.2.2.34.1.1 | NodeusdEthernetIfLayer | |||
| 1.3.6.1.4.1.4874.2.2.34.1.1.1 | TableusdEthernetIfTable | not-accessible | current | The parameters for the Ethernet interface. |
| 1.3.6.1.4.1.4874.2.2.34.1.1.1.1 | RowusdEthernetIfEntry | not-accessible | current | The Parameters for a particular Ethernet interface. Entries in this table correspond with entries in the ifTable/ifXTable/usdIfTable. |
| 1.3.6.1.4.1.4874.2.2.34.1.1.1.1.1 | ColumnusdEthernetIfIndex | not-accessible | current | The ifIndex value of the corresponding ethernet interface. |
| 1.3.6.1.4.1.4874.2.2.34.1.1.1.1.2 | ColumnusdEthernetIfDuplexMode | read-write | current | The configured duplex setting for this ethernet interface. The operational value is reported in this table entry's corresponding usdEthernetIfOperDuplexMode ob… |
| 1.3.6.1.4.1.4874.2.2.34.1.1.1.1.3 | ColumnusdEthernetIfSpeed | read-write | current | The configured speed setting for this ethernet interface. The operational value is reported in the corresponding Interfaces MIB ifSpeed object. NOTE, configura… |
| 1.3.6.1.4.1.4874.2.2.34.1.1.1.1.4 | ColumnusdEthernetIfMtu | read-write | current | The configured maximum transfer unit (MTU) for this ethernet interface. The operational value is reported in the corresponding Interfaces MIB ifMtu object. |
| 1.3.6.1.4.1.4874.2.2.34.1.1.1.1.5 | ColumnusdEthernetIfOperDuplexMode | read-only | current | The current operational duplex mode for this ethernet interface. |
| 1.3.6.1.4.1.4874.2.2.34.1.2 | NodeusdEthernetSubIfLayer | |||
| 1.3.6.1.4.1.4874.2.2.34.1.2.1 | ScalarusdEthernetSubIfNextIfIndex | read-only | current | Coordinate ifIndex value allocation for entries in usdEthernetSubIfTable. A GET of this object returns the next available ifIndex value to be used to create an… |
| 1.3.6.1.4.1.4874.2.2.34.1.2.2 | TableusdEthernetSubIfTable | not-accessible | current | This table contains entries for Ethernet Subinterfaces present in the system. |
| 1.3.6.1.4.1.4874.2.2.34.1.2.2.1 | RowusdEthernetSubIfEntry | not-accessible | current | Each entry describes the characteristics of an Ethernet Subinterface. Creating/deleting entries in this table causes corresponding entries for be created/delet… |
| 1.3.6.1.4.1.4874.2.2.34.1.2.2.1.1 | ColumnusdEthernetSubIfIndex | not-accessible | current | The ifIndex of the Ethernet Subinterface. When creating entries in this table, suitable values for this object are determined by reading usdEthernetSubNextIfIn… |
| 1.3.6.1.4.1.4874.2.2.34.1.2.2.1.2 | ColumnusdEthernetSubIfRowStatus | read-create | current | Controls creation/deletion of entries in this table according to the RowStatus textual convention, constrained to support the following values only: createAndG… |
| 1.3.6.1.4.1.4874.2.2.34.1.2.2.1.3 | ColumnusdEthernetSubIfLowerIfIndex | read-create | current | The ifIndex of a Ethernet interface over which this Ethernet Subinterface is to be layered. A value of zero indicates no layering. An implementation may choose… |
| 1.3.6.1.4.1.4874.2.2.34.1.2.2.1.4 | ColumnusdEthernetSubIfId | read-create | current | An integer identifier for the Ethernet subinterface, used in conjunction with the command-line interface. It is provided here for cross-reference purposes only… |
| 1.3.6.1.4.1.4874.2.2.34.1.3 | NodeusdVlanMajorIfLayer | |||
| 1.3.6.1.4.1.4874.2.2.34.1.3.1 | ScalarusdVlanMajorNextIfIndex | read-only | current | Coordinate ifIndex value allocation for entries in usdVlanMajorIfTable. A GET of this object returns the next available ifIndex value to be used to create an e… |
| 1.3.6.1.4.1.4874.2.2.34.1.3.2 | TableusdVlanMajorIfTable | not-accessible | current | This table contains entries for major VLAN interfaces present in the system. |
| 1.3.6.1.4.1.4874.2.2.34.1.3.2.1 | RowusdVlanMajorIfEntry | not-accessible | current | Each entry describes the characteristics of a major VLAN interface. Creating/deleting entries in this table causes corresponding entries for be created/deleted… |
| 1.3.6.1.4.1.4874.2.2.34.1.3.2.1.1 | ColumnusdVlanMajorIfIndex | not-accessible | current | The ifIndex of the major VLAN interface. When creating entries in this table, suitable values for this object are determined by reading usdVlanMajorNextIfIndex. |
| 1.3.6.1.4.1.4874.2.2.34.1.3.2.1.2 | ColumnusdVlanMajorIfLowerIfIndex | read-create | current | The ifIndex of the interface over which this major VLAN interface is to be layered. A value of zero indicates no layering. An implementation may choose to requ… |
| 1.3.6.1.4.1.4874.2.2.34.1.3.2.1.3 | ColumnusdVlanMajorIfRowStatus | read-create | current | Controls creation/deletion of entries in this table according to the RowStatus textual convention, constrained to support the following values only: createAndG… |
| 1.3.6.1.4.1.4874.2.2.34.1.4 | NodeusdVlanSubIfLayer | |||
| 1.3.6.1.4.1.4874.2.2.34.1.4.1 | ScalarusdVlanSubNextIfIndex | read-only | current | Coordinate ifIndex value allocation for entries in usdVlanSubIfTable. A GET of this object returns the next available ifIndex value to be used to create an ent… |
| 1.3.6.1.4.1.4874.2.2.34.1.4.2 | TableusdVlanSubIfTable | not-accessible | current | This table contains entries for VLAN Subinterfaces present in the system. |
| 1.3.6.1.4.1.4874.2.2.34.1.4.2.1 | RowusdVlanSubIfEntry | not-accessible | current | Each entry describes the characteristics of a VLAN Subinterface. Creating/deleting entries in this table causes corresponding entries for be created/deleted in… |
| 1.3.6.1.4.1.4874.2.2.34.1.4.2.1.1 | ColumnusdVlanSubIfIndex | not-accessible | current | The ifIndex of the VLAN Subinterface. When creating entries in this table, suitable values for this object are determined by reading usdVlanSubNextIfIndex. |
| 1.3.6.1.4.1.4874.2.2.34.1.4.2.1.2 | ColumnusdVlanSubIfVlanId | read-create | current | An integer identifier or tag ID for this VLAN A value of zero indicates the default VLAN. When VLANs are enabled, the value must be unique among subinterfaces … |
| 1.3.6.1.4.1.4874.2.2.34.1.4.2.1.3 | ColumnusdVlanSubIfVlanUntagged | read-create | current | When VLANs are enabled, this allows tagged frames to be received, while transmitted frames remain untagged. This can only be enabled when the usdVlanSubIfVlanI… |
| 1.3.6.1.4.1.4874.2.2.34.1.4.2.1.4 | ColumnusdVlanSubIfLowerIfIndex | read-create | current | The ifIndex of VLAN major interface over which this VLAN Subinterface is to be layered. A value of zero indicates no layering. An implementation may choose to … |
| 1.3.6.1.4.1.4874.2.2.34.1.4.2.1.5 | ColumnusdVlanSubIfRowStatus | read-create | current | Controls creation/deletion of entries in this table according to the RowStatus textual convention, constrained to support the following values only: createAndG… |
| 1.3.6.1.4.1.4874.2.2.34.1.4.2.1.6 | ColumnusdVlanSubIfVlanStackId | read-create | current | An integer identifier or tag ID for this S-VLAN. When S-VLANs are enabled, the VLAN and S-VLAN ID valuse must be unique among subinterfaces configured on the s… |
| 1.3.6.1.4.1.4874.2.2.34.1.4.2.1.7 | ColumnusdVlanSubIfVlanStackEthertype | read-create | current | The ethertype is used to recognize and demultiplex traffic for this S-VLAN. Must be either 0x9100 or 0x9200. Cannot be changed if the subinterface has upper bi… |
| 1.3.6.1.4.1.4874.2.2.34.4 | NodeusdEthernetConformance | |||
| 1.3.6.1.4.1.4874.2.2.34.4.1 | NodeusdEthernetCompliances | |||
| 1.3.6.1.4.1.4874.2.2.34.4.1.1 | ComplianceusdEthernetCompliance | obsolete | Obsolete compliance statement for entities which implement the Unisphere Ethernet MIB. This statement became obsolete when support for VLANs was added. | |
| 1.3.6.1.4.1.4874.2.2.34.4.1.2 | ComplianceusdEthernetCompliance2 | obsolete | Obsolete compliance statement for entities which implement the Unisphere Ethernet MIB. This statement became obsolete when VLAN stack support was added. | |
| 1.3.6.1.4.1.4874.2.2.34.4.1.3 | ComplianceusdEthernetCompliance3 | current | The compliance statement for entities which implement the Unisphere Ethernet MIB. | |
| 1.3.6.1.4.1.4874.2.2.34.4.2 | NodeusdEthernetGroups | |||
| 1.3.6.1.4.1.4874.2.2.34.4.2.1 | GroupusdEthernetGroup | current | A collection of objects providing management of Ethernet interfaces in a Unisphere product. | |
| 1.3.6.1.4.1.4874.2.2.34.4.2.2 | GroupusdEthernetSubIfGroup | current | A collection of objects providing management of Ethernet SubInterfaces in a Unisphere product. | |
| 1.3.6.1.4.1.4874.2.2.34.4.2.3 | GroupusdVlanGroup | current | A collection of objects providing management of Major VLAN interfaces in a Unisphere product. | |
| 1.3.6.1.4.1.4874.2.2.34.4.2.4 | GroupusdVlanSubIfGroup | obsolete | Obsolete collection of objects providing management of VLAN SubInterfaces in a Unisphere product. This group became obsolete when VLAN stack support was added. | |
| 1.3.6.1.4.1.4874.2.2.34.4.2.5 | GroupusdVlanSubIfGroup2 | current | A collection of objects providing management of VLAN SubInterfaces in a Unisphere product. |