The command status for this port configuration row/record. The value used in a SET will be replaced by a response value in the GET RESPONSE indicating success or failure. Default Response State used in GET RESPONSE Command ready-for-command (0) initial default status for a row DS0-DP Port Commands used in SET Command (1..99) update(1) Change existing Port Configuration inServiceAll (7) Change Link Status to in-service for all 8 ports. copyToAll (9) Copy DS0-DP Port configuration to all other ports within the same device outOfServiceAll (12) Change Link Status to out-of-service for all 8 ports. Response States used in GET RESPONSE Command (100..199) update-successful (101) DS0-DP Port data has been successfully changed insvc-successful (107) All Ports have been successfully placed In Service copy-successful (109) DS0-DP Port data has been successfully copied to other ports oos-successful (112) All Ports have been successfully placed Out of Service DS0DP Port Error Codes used in GET RESPONSE Command (200..699) err-general-config-error (400) Unknown DS0-DP port configuration error occurred err-invalid-port-status (401) Unrecognized DS0-DP port status setting err-invalid-port-command (403) Unrecognized DS0-DP port command-action err-invalid-zero-code (406) Unrecognized zero code enforcement setting err-invalid-port-rate (407) Unrecognized DS0-DP Rate err-invalid-network-loop (410) Unrecognized loop detect setting setting err-data-locked-by-another-user (450) Another administrative user is making changes to this part of the system via a terminal session. Check Event Log for user name err-snmp-parse-failed (500) Agent could not parse variable err-invalid-snmp-type (501) Variable ASN type does not match Agent defined type err-invalid-snmp-var-size (502) Variable size is too big